PRODUCT INFORMATION DATA SHEETS

BARCOAT

Quick Drying Isolator/Adhesion Promoter

• Fast drying - can be top-coated in one hour
• Ready for use
• Non-sanding formula
• Prevents bleeding and lifting of existing paint film that is sensitive to solvent attack
• Helps prevent body filler bleed through
• One litre will cover most automobiles
• Can be used for spot repair
• Use as an adhesion promoter on most plastics

DESCRIPTION: Barcoat is a quick drying yellow oxide isolator. It is designed to prevent lifting and bleeding of existing paint film sensitive to solvent attack when over-coated with cellulose or paint containing strong solvents.

SURFACE PREPARATION INSTRUCTIONS FOR USE: Thoroughly clean and de-wax the old paint surface with a spirit wipe or suitable solvent. Wet sand with P400 paper, re-clean and dry thoroughly. For metal use P180 paper.

APPLICATION: Stir well and filter before use. Only one light, even coat is required. Use a suction feed gun, fluid tip 1.4mm - 1.8mm, check first that the air line is free of moisture. Do not use silicon or flow additives or allow the paint film to become wet after use.

BUILD AND PRESSURE: One light even coat of Barcoat will give a build of approximately 15-25 microns. A pressure of 3.5-4.0 BAR is required at the gun.

DRYING TIME: Approximately 1 hour at normal shop temperatures. Drying time is dependant on film thickness, humidity and temperature.

OVER-PAINTING: Barcoat should be over coated with primer/surfacer. Barcoat should not be sanded before application of further coats of paint.