PRODUCT INFORMATION DATA SHEETS

2020  HS  PRIMER  FILLER

High solids two component acrylic coating, which can be used as multi-role coating:

PREPARATION OF SURFACE:

  1. Degrease surface
  2. Original paint: wet flat P320 or dry flat P280.
    Bare metal: Abrade with P120 steel, aluminium or zinc coated steel.
    Apply 2 light coats of ACID#8 1K etch primer, allow to dry for 20 minutes.
    GRP Glass fibre, Polyester Filler: Dry flat P240
  3. Degrease.

Colour

 

 

Beige

 

Spray Filler

Primer Surfacer

Wet on Wet

 

 

 

Surfacer

Mixing ratio

 

 

 

Products 2020  /  2030  /  2041

3:1

3:1:10%

3:1:20%

 

 

 

 

Spray Tip

2.0-2.2

1.6-1.8

1.4-1.6

Viscosity DIN 4/sec.

45-55

30-35

20-25

Air Pressure / Bar

4

4

4

Coats

1-2

2-3

1-2

Build / mircons

180

200-220

30-60

Flash off/minutes

15

10

10

Dry to sand air/hours

8-10

5-6

2-3

Dry to sand 600C/min

20-30

20-30

0-30

Dry to sand I.R./min

15

15

15

Pot-life/hours

2-3

2-3

2-3

Wet Sanding/abrasive

600-800

600-800

600-800

Dry Sanding/abrasive

320-400

320-400

320-400

 

TEMPERATURE RANGE FOR USE OF SYSTEM 20 2030 SERIES HARDENERS

Temp 0C

-5

0

5

10

15

20

25

30

35

40

over45

Hardener

 

 

 

 

 

 

 

 

 

 

 

2031  Extra Fast

 

 

 

 

 

 

 

 

 

 

 

2030  Fast

 

 

 

 

 

 

 

 

 

 

 

2032  Standard

 

 

 

 

 

 

 

 

 

 

 

2033  Slow